A6 Sedan V6-2.8L (ATQ) (2000)
NOTE: To facilitate disassembling and assembly, make an auxiliary tool from welding wire as shown.
Dimension -a- = 300 mm (11.8 in.)
Dimension -b- = 20 mm (0.78 in.)
Dimension -c- = 10 mm (0.39 in.)
Dimension -d- = 10 mm (0.39 in.)
NOTE: The door handle is shown removed to clarify the illustration.
-
Remove door trim panel.
-
Run door window up to top position.
-
Hook auxiliary tool - 3 - around fulcrum lever - 1 - as shown and partially pull out locking pin - 2 - in direction of arrow - A -.
-
Use auxiliary tool - 3 - to pull locking pin - 2 - completely out of fulcrum lever - 1 - in direction of arrow - A -.
-
Pivot fulcrum lever - 1 - upward.
-
Using small screwdriver, disengage retainer for slide (arrow - B -) by lifting it slightly.
-
Disengage slide - 4 - in direction of arrow - C -.
-
Remove door handle together with lock cylinder outward.
-
Pull off door handle mount inward.
-
Install in reverse order of removal.