A6 Sedan V6-2.8L (ATQ) (2000)
License Plate Bracket: Technical Service Bulletins
Body - Rear License Plate Fastener Replacement
66 08 11
2001868/3
December 2, 2008.
Supersedes Technical Service Bulletin Group 66 number 07-05 dated August 9, 2007 for reasons listed below.
Affected vehicles
66 Rear license plate, replacing damaged fasteners
Condition
Rear license plate fasteners broken, loose or fallen behind license plate holder / lens assembly.
Technical Background
Production Solution
Service
1. Remove rear license plate and license plate holder / lens assembly.
2. Carefully remove the four existing cage nuts.
3. Install license plate holder / lens assembly.
4. Install replacement license plate fasteners (Part No: N 909 460 01) into existing holes (Figure 1). Make sure the fasteners are flush with the license
plate holder.
Figure 1
1. Install license plate using new screws Part No: N 909 457 01.
2. If a license plate trim plate is not installed along with the license plate, add an approximately 1 mm thick washer to the installation screws to
prevent screws from bottoming out. Do not overtighten license plate screws.
Warranty