A6 Sedan V6-2.8L (ATQ) (2000)
Crankshaft Main Bearing Seal: Service and Repair
Rear seal (dual-mass flywheel/drive plate side)
Note:
-
If possible, always replace the seal together with the flange.
-
Drain the engine coolant before removing the flange.
-
Remove drive plate or pressure plate, clutch and dual-mass flywheel.
-
Pry out seal using 10-221 extractor.
-
Clean running and sealing surfaces.
Note: Do not lubricate sealing lip or outer edge of seal before pressing in.
-
Push seal onto crankshaft using assembly aid.
Note: The assembly aid is supplied with the seal.
-
Press in seal up to stop using 2003/3 seal installer and bolts for dual-mass flywheel or drive plate.