A6 Sedan V6-2.8L (ATQ) (2000)
Air Door Actuator / Motor: Service and Repair
Central Air Flap Motor -V70-
Central Air Flap Motor -V70-, Removing And Installing
-
Remove glove box
-
Disconnect harness connector -A-.
-
Remove 3 bolts -B-.
-
Carefully disengage coupling rod -C- using screwdriver -D- and remove positioning motor.
Notes for installation:
-
After installing, always carry out On Board Diagnostic (OBD) of air conditioning system.
-
When installing the positioning motor, make sure that coupling rod -C- is properly engaged.
-
When installing the positioning motor, make sure that the location pin on the actuating arm engages properly in the cam plate.
-
Install the wiring harness so that it cannot come in contact with any moving parts (e.g. the actuating arm on the positioning motor).