A6 Sedan V6-2.8L (ATQ) (2000)
Harness connector Terminal
VAG1598/31 test box Socket
1 (B+)
98
2 (signal)
86
3 (Ground -GND-)
108
Camshaft Position (CMP) Sensor 2 -G163- (bank 2)
Harness connector Terminal
VAG1598/31 test box Socket
1 (B+)
98
2 (signal)
87
3 (Ground -GND-)
108
-
Repair open circuit or short circuit if necessary.
-
If, after erasing DTC memory for the sake of the test, a DTC relating to the Camshaft Position (CMP) sensor (hall sensor) is indicated again, even
though all previous tests were OK, the following malfunction is possible:
-
Shutter wheel for Camshaft Position (CMP) sensor is not aligned properly.
Check phase position of Camshaft Position (CMP) sensor
-
Connect VAS5O51 tester or VAG1551 scan tool and select the control module for engine electronics using "address word" 01. Refer to "Scan
Tool Testing/Scan Tool Connecting And Initial Checks", See: Testing and Inspection
Engine must run at idle for this.
When indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.
When indicated on display:
Read Measuring Value Block
Q
Input display group number XXX
-
Press buttons -0-, -9- and -3- to select "display group number 093" and press -Q- button to confirm input.
When indicated on display:
Read Measuring Value Block 93
->
1
2
3
4
-
Check specified values of Camshaft Position (CMP) sensor