A6 Sedan V6-2.8L (ATQ) (2000)
Evaporative Emission Control Canister: Service and Repair
EVAP Canister, Removing and Installing
Emission Evaporative (EVAP) Canister, Removing And Installing
NOTE:
-
Secure all hose connectors with hose clamps, which correspond to the series conditions.
-
Check seal integrity, performing tank leak diagnosis.
Removing
-
Remove cover for EVAP canister at bottom of spare tire well.
-
Loosen hose connections 1 to 3 on vent lines.
-
Remove sealing parts above vent lines.
-
Unbolt studs -arrows- and remove EVAP canister.
Installing
Installation is performed in the reverse order of the removal procedure, during installation note the following:
NOTE: Secure all hose connectors with hose clamps, which correspond to the series conditions.
CAUTION: Always refer to the latest parts catalog to ensure that you use original equipment fuel hose clamps.
Tightening torque
Component
Nm
EVAP canister on Body
15 Nm (11 ft lb)
Cover on spare wheel well
10 Nm (7 ft lb)