A6 Sedan V6-2.8L (ATQ) (2000)
-
Connect VAG1527B voltage tester between sockets 2 (CMP sensor signal) and 1(B+).
NOTE: Connector socket numbers are shown on the rear side of the connector.
-
Operate starter for a few seconds.
-
LED must blink briefly at every second engine rotation.
NOTE: Voltage testers do not go out completely during low current pick-up between activations by the ECM, but rather continue to glow a little and
then get significantly brighter during activation.
If LED does not blink:
Checking voltage supply
-
Disconnect connector at respective Camshaft Position (CMP) sensor.
-
Switch ignition on.
-
Connect multimeter for voltage measurement as follows:
Harness connector Terminal
Measure to
1
Engine Ground (GND)
-
Specification: about 5 V
Checking signal wire