A6 Sedan V6-2.8L (ATQ) (2000)
Control Module: Service and Repair
Kick Down Function, Adapting
Kick Down Function, Adapting
If the sensor for accelerator pedal position or the Engine Control Module (ECM) is replaced on a vehicle with automatic/variable transmission, the kick
down function must be learned by the ECM.
Special Tools and Equipment
-
VAS5051 with VAG5051/1
or
-
VAG1551 with VAG1551/3B
Requirements
-
No DTCs in DTC memory, check DTC memory.
-
Engine not running, ignition switched on.
Procedure
-
Connect VAS5051 tester or VAG1551 scan tool and select the control module for engine electronics using "address word" 01.
Ignition must remain switched on for this.
When indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -4- to select "Initiate basic setting" and press -Q- button to confirm input.
When indicated on display:
Basic Setting
Q
Input display group number XXX
-
Press buttons -0-, -6- and -3- to select "display group number 063" and press -Q- button to confirm input.
When indicated on display:
System in Basic Setting 63
->
1
2
3
4
NOTE: There will be a prompt: "Activate kick-down"
-
Depress accelerator pedal completely, past kick down point, and hold down.
NOTE: During adaptation of the kick down point, the VAG1551 will display "Kick down ADP in progress". After successful adaptation of the kick