A6 Sedan V6-2.8L (ATQ) (2000)
Power Steering Fluid Level Sensor/Switch: Service and Repair
Operation Switch At Multi-function Steering Wheel, Removing And Installing
Removing
-
Disconnect battery ground (GND) strap.
NOTE: Always follow airbag safety precautions when working on airbag system components
-
Unlatch steering column adjustment. Pull steering wheel as far out and up as possible.
-
Remove airbag unit by removing bolts at left and right at steering wheel using a T30 Torx bit. Tightening torque: 6 Nm
-
Carefully flip airbag unit forward.
-
Disconnect connectors -1- and -2- at airbag unit.
-
Remove airbag unit.
-
Disconnect connector -3- and remove both T1O Torx screws at left or right operating switch.
-
Remove operating switch toward front.
Installing:
NOTE: During installation, make sure that connecting wire of connector -3- is in guides and is not pinched.
-
Install in reverse order of removal.