A6 Sedan V6-2.8L (ATQ) (2000)
-
Install lower track control links and lower guide links in subframe.
-
Install bolts in outer holes (arrows).
^
Before tightening, 3393 testing mandrel must be installed to align subframe to body
^
Hole -1-, subframe hole -2- and aluminum console hole -3- must align on both sides
Notes:
^
When installing the complete subframe, the 3393 testing mandrel can be used to align the subframe to the body only if holes -1- and -2- were
aligned before the repairs were made.
^
If the 3393 testing mandrel is not used when installing the subframe or if holes -1- and -2- did not align before repairs were made a wheel
alignment will need to be carried out.
-
Loosely install bolts -1- and -2-.
-
Loosely install bolts -3- and -4-.
-
Carry out corrosion protection measures, as needed, to holes used for 3393 testing mandrel.
Tightening sequence and tightening torques
CAUTION: The bonded rubber bushings can only be turned to a limited extent. The bolted connections on the suspension links should therefore only
be tightened when the vehicle is standing on the ground