A6 Sedan V6-2.8L (ATQ) (2000)
/Page-5149002.png)
-
Drive out tensioning pin -1- at transmission selector lever -2- in driving direction (arrow) until the transmission shift lever can be pulled off the
shift rod.
-
Push small screwdriver though seal and pull out seal.
Installing
-
Coat outer circumference and area between sealing lips with ATF.
^
Installation position: Open side of seal points toward transmission.
-
Slide new seal onto 3385 sealing ring installer and drive in to stop of 3385, and make sure not to cant seal while doing so.
-
Install multi-function Transmission Range (TR) switch -F125-.
-
Drive out tensioning pin in opposite direction via the lever while transmission shift lever is still removed.
-
Slide transmission shift lever onto the shift rod and drive in tensioning pin.
-
Remove left transmission support.
