A6 Sedan V6-2.8L (ATQ) (2000)
^
For wiring harness
^
Engage wiring harness on bracket
^
Attached with bolts for valve body
11. Bolt
^
6 Nm (53 inch lbs.)
12. Transmission Vehicle Speed Sensor (VSS) -G38-
^
Replacing
13. Spacer sleeve
^
Length: 8 mm (5/16 inch)
14. Internal oil line
^
Always replace
15. O-ring
^
Always replace
16. Speedometer Vehicle Speed Sensor (VSS) -G22-
^
Replacing
17. O-ring
^
Always replace
18. Multi-function Transmission Range (TR) switch -F125-
^
Replacing
19. Bolt
^
8 Nm (71 inch lbs.)
20. O-ring
^
Always replace
21. Securing clip
22. Wiring harness
^
Replacing
^
Transmission fluid temperature sensor -G93- integrated into wiring harness
^
Remove and install valve body to replace wiring harness
^
Disengage from wiring harness bracket -10-
^
Installation position of wiring harness connector: flat part of backing collar points down, tabs on collar are horizontal
23. Bolt
^
6 Nm (53 inch lbs.)
24. Sensor for transmission RPM -G182-
^
Replacing
25. Spacer sleeve
^
Length: 20 mm (25/32 inch)
26. Bolt
^
6 Nm (53 inch lbs.)
27. Bracket
^
For solenoid valve
28. Solenoid valve 4 -N91-
^
With O-ring
^
To replace: remove and install valve body
29. Solenoid valve 3 -N90-
^
Without O-ring
^
To replace: remove and install oil pan
30. Solenoid valve 2 -N89-
^
Without O-ring
^
To replace: remove and install oil pan
31. Bolt
^
6 Nm (53 inch lbs.)
32. Bracket
^
For solenoid valves
33. Solenoid valve 6 -N93-
^
With O-ring
^
To replace: remove and install oil pan
34. Solenoid valve 7 -N94-
^
With O-ring
^
To replace: remove and install oil pan
35. Solenoid valve 5 -N92-
^
With O-ring
^
To replace: remove and install oil pan
36. Solenoid valve 1 -N88-
^
Without O-ring
^
To replace: remove and install oil pan and remove guide plate for parking lock mechanism
^
When installing, do not tighten bolts for guide plate (tightening torque: 23 Nm/17 ft. lbs.) while selector lever is in "P" position