A6 Sedan V6-2.8L (ATQ) (2000)
Assembly of suspension strut
-
Slide small clamp for CV boot onto shaft.
-
Slide new CV boot onto shaft.
-
Slide joint piece onto shaft.
-
Slide CV boot onto joint piece.
Mount triple roller connection.
-
Chamfer (arrow) on connection faces toward shaft, it facilitates assembly.
-
Place triple roller connections on shaft according to markings and drive on until impact.
-
Insert securing ring, be sure to fit properly.
-
Press 70 grams of G 000 605 drive axle grease from repair set into triple roller joint.
-
Slide joint piece over rollers.
Note: Be sure that CV boot does not get twisted during this.
-
Press 70 grams of G 000 605 drive axle grease from repair set into back of triple roller joint.
-
Clean groove for sealing ring.
-
Insert sealing ring into groove -1
-
For the sake of illustration, individual parts are shown removed.
1. Snap ring
2. Cover from repair kit
3. Sealing ring
4. Triple roller joint