A6 Sedan V6-2.8L (ATQ) (2000)
-
Press triple roller star onto drive axle
-
Securing ring must engage audibly, triple roller star must contact securing ring gap-free.
-
Install securing ring.
1. Pliers (commercially available)
-
Press 70 grams of G 000 605 drive axle grease from repair set into back of triple roller joint.
-
Lightly grease roller body
-
Make sure roller bodies do not cant
-
Press joint piece over triple roller star using a plastic mallet
-
Press remaining amount of grease into CV boot.
-
Make sure boot is properly seated on joint piece.
-
Boot must make contact in the groove and the contour of the joint piece
-
Position joint piece in center position. See min - max position
Note: Vent CV boot, e.g. using a screwdriver, while positioning joint piece in center position. (Arrow)