A6 Sedan V6-3.2L (BKH) (2007)
-
Remove remaining brake lines - arrows - from hydraulic unit.
-
Seal the brake lines and threaded bores with sealing plugs from the repair set.
-
Push the red circlip upward.
‹› Make sure that no brake fluid gets into the control module connector housing. This could lead to corrosion of the contacts and thereby cause the
system to fail.
‹› Clean a dirty connector housing thoroughly with compressed air.
-
Release connector at control module - arrow - and remove.
-
Slide securing bracket in - direction of arrow - and remove connector.