A6 Sedan V6-3.2L (BKH) (2007)
/Page-2219011.png)
‹› The groove of sealing surface must be completely filled with sealant.
‹› The sealant beads must be 1.5 to 2.0 mm above the sealing surface.
‹› The sealant bead - 2 - must be pulled through as shown in the illustration even though the groove is intermittent.
-
Insert seals - arrows - in lower timing chain cover grooves.
-
Set the lower timing chain cover in place, guiding the cover at an angle from below onto the sealing surface of the cylinder block and cylinder
head.
