A6 Sedan V6-3.2L (BKH) (2007)
Fuse Block: Service and Repair
Driver's Side Fuse Panel and 2-Pin Relay
Driver's Side Fuse Panel and 2-Pin Relay
Removing
-
With ignition switched off, disconnect battery Ground (GND) wire. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and
Charging/Battery/Service and Repair/Battery.
-
Remove lower instrument panel cover on driver's side.
-
Remove screws - arrows -.
-
Remove relay and fuse panel - 1 -.
If necessary, proceed with work steps.
-
Unclip fuse panel at relay and fuse panel.
-
Disconnect relays and unclip respective relay carrier.
‹› For the exact assignment of the 2-pin relay and fuse panel behind instrument panel on driver's side, refer to the current wiring diagram. Wiring
diagrams, Troubleshooting & Component locations.
Installing
Install in reverse order of removal, observing the following:
-
Install lower instrument panel cover on driver's side.
-
Connect battery. Required actions => [ ] See: Starting and Charging/Battery/Service and Repair/Battery.
Tightening Specifications