A6 Sedan V6-3.2L (BKH) (2007)
/Page-2631001.png)
Fuel Pressure Sensor/Switch: Testing and Inspection
Fuel Pressure Sensor G247, Checking
Fuel Pressure Sensor G247, Checking
Special tools, testers and auxiliary items required
-
Multimeter V.A.G 1526 A or equivalent.
-
Test Box 105 Pin VAG1598/42 .
-
Adapter Lead VAG 1598/39 VAG1598/39-1 .
Test requirements
-
Fuel Pump (FP) Control Module J538 OK; check.
-
The fuses for the engine electronics OK.
-
The fuel filter OK The parking brake engaged.
-
The battery voltage at least 12.5 V.
-
The selector lever of automatic transmission in position "P" or "N".
-
All electrical consumers switched off (radiator fan must NOT run during test).
-
A/C switched off.
-
The fuel tank at least 1 / 4 filled.
-
The ignition switched off.
Procedure
Checking voltage
-
Disconnect the 14 pin electrical harness connector - 3 - for Fuel Pressure Sensor G247 from the left rear of the engine.
-
Using the Multimeter V.A.G. 1526 A or equivalent, check the Fuel Pressure Sensor G247 for voltage at the 14 pin electrical harness connector.
14 pin electrical harness connector Terminal
Specified value
1 to Battery positive (+)
Battery positive (+)
2 to Ground (GND)
Battery positive (+)
3 to Ground (GND)
about 5 V
If specified value is obtained:
-
Remove the intake manifold upper-part and replace the Fuel Pressure Sensor G247 : 3.2 V6 4 V Engine Mechanical, Engine Code(s):
If the specified value was not obtained:
Checking wiring connections
-
Connect the test box 1598/42 to the wiring harness of the SIMOS Control Module J361 with adapter cable 1598/39-1; the ECM is not connected.
-
Using the Test Box 105 Pin VAG1598/42 and Multimeter V.A.G 1526 A or equivalent, check the following wire connection for an open circuit.
14 pin electrical harness connector Terminal
Test box Socket
1
40
2
59
3
29
Specified value: Wire resistance max 1.5 ohms
If the specification is not obtained:
