A6 Sedan V6-3.2L (BKH) (2007)
-
Install rear shelf:
Rear shelf without sun shade => [ Rear Shelf without Sun Shade ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal
and Replacement/Trim
Rear shelf with sun shade => [ Rear Shelf with Sun Shade ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal and
Replacement/Trim.
-
Install rear center floor assembly anchorage point (belt buckle with right retainer).
‹› Ensure belt roller/belt tensioner - 1 - is not obstructed by wires, insulation, etc.
‹› Ensure belt webbing is not twisted.
Further installation takes in reverse order of removal.
Vehicles with pyrotechnic belt tensioners
-
Perform belt wear detection => [ Rear Three Point Seat Belt with Belt Tensioner, Checking Belt Fastening
Detection ] See: Testing and Inspection/Seat Belts, Inspecting.
2
Noise protection cap
‹› Glued to belt roller/belt tensioner
3
Screw - 55 Nm
‹› In delivery casing
‹› If rear center three-point seat belt is being removed for accident repairs, replace screw
4
Securing hook
‹› On belt roller/tensioner base plate
5
Rear shelf crossmember
6
Rear center belt guide
‹› Only for vehicles with solid rear seat backrest
7
Rear Shelf
Removing and Installing pyrotechnic belt tensioner ignition pill connector
‹› Removing: