A6 Sedan V6-3.2L (BKH) (2007)
Alignment: Procedures
Toe Constant S, Adjusting
Toe Constant S, Adjusting
-
Loosen hex head nut - A -.
-
Remove bolt - B - approximately 4 mm.
-
Push tie rod joint downwards onto stop.
‹› Do not use a chisel or similar tool between steering arm - 1 - sealing washer - 2 - when removing tie rod, otherwise sealing washer could be
damaged.
‹› Tie rod may only be pressed off steering arm over tie rod ball joint pin ends or driven with a wooden or rubber hammer.
-
Install bolt - B - until specified value is reached exactly.