A6 Sedan V6-3.2L (BKH) (2007)
6
Wheel bearing unit
‹› Removing and installing, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing/Service and Repair/Removal and Replacement/Rear
Suspension/Wheel Bearing Unit
‹› A complete wheel bearing unit is installed only on FWD vehicles
‹› The wheel bearing unit cannot be serviced.
7
Bolt
‹› 200 Nm plus an additional 180° turn
‹› Always replace after removal
8
Brake disc cover plate
9
Hex head screw
10
Bolt
‹› 85 Nm plus an additional 90° turn
‹› Always replace after removal
11
Tie Rod
12
Stone protection plate
‹› Only installed on vehicles with heavy duty suspension
13
Locking clip
14
Nut
15
Bolt
‹› 85 Nm plus an additional 90° turn
‹› Always replace after removal
16
Trapezium control arm with stone deflector
17
Nut
18
Washer
19
Shock Absorbers
‹› Removing and installing, refer to => [ Shock Absorber Coil Spring ] See: Suspension Spring ( Coil / Leaf )/Service and Repair/Shock
Absorber Coil Spring
20
Protective sleeve
‹› Mounted on the buffer stop and mounting ring on the RS 6
‹› Pay attention to the position on the RS 6 => [ Protective sleeve position on the RS 6 ]
21
Buffer stop
22
Bolt
‹› 35 Nm
23
Shock absorber mounting