A6 Sedan V6-3.2L (BKH) (2007)
-
Slide noise insulation - 2 - forward.
-
Remove rubber boots - 3 - from lower selector mechanism cover - 4 -.
-
Remove nuts - 5 -.
-
Swing lower selector mechanism cover and noise insulation forward.
-
Remove selector lever cable retaining clamp - 1 - on shift mechanism downward.
-
Pull plastic securing spring - 2 - slightly to front and push pins - 3 - upward with a screwdriver only as far as necessary.
‹› Make sure that pin is not pushed fully out.
-
Remove selector lever cable - 4 - from shift mechanism.
Installing
Install in reverse order, paying attention to the following: