A8 Quattro Sedan V8-4.2L (AKB) (2002)
-
Pull out trim panel - 1 - at upper B-pillar.
-
Remove trim - 1 - from clip - 7 - by moving back and forth lightly.
-
Unclip trim from A-pillar - 2 -.
-
Pull A-pillar trim - 1 - upward out of tab - 6 -.
WARNING: Always observe installation sequence for A-pillar trim.
-
Installing:
-
Remove clip - 7 - from A-pillar by pressing together center of clip (always replace clip).
-
Insert new clamp - 7 - in A-pillar trim - 1 - and press in retaining clamp - 8 - (check to be sure it is securely fitted).
-
Clamp - 7 - must be positioned vertically to supporting surface.
-
Clip in protrusion - 10 - at front cut-out of A-pillar trim - 1 - for grab handle.
-
Protrusion must be next to clamp - 8 - (secure using hot glue).
-
Insert A-pillar trim - 1 - in tab - 6 -.
-
Position trim at clips.
WARNING: Be sure trim is securely installed.
-
Guide A-pillar trim - 1 - into rubber door seal.
-
Install bolt - 3 -.
-
Install grab handle.