A8 Quattro Sedan V8-4.2L (AKB) (2002)
/Page-218003.png)
(measurement taken between terminals 1 and 2 without unplugging connector and while operating starter):
-
Replace relevant Hall sensor.
If the readouts do not match the specification, check the wiring.
Checking wiring between Hall sensor and engine control module
-
Connect VAG1598/31 test box to wiring harness for engine control module. Do not connect to the engine control module itself. Refer to "Scan
Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG1598/31 Test Box" See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
-
Check wiring connection from Hall sensor to engine control module for open circuit and/or short circuit to B+ or Ground (GND).
