audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

All Other Service Bulletins for Wheel Speed Sensor:|600101|Page 3810 > < All Other Service Bulletins for Wheel Speed Sensor:|600101
Page 2
background image

-

Check drain hose at sunroof connecting point (arrows) to ensure that tube is not kinked.

-

Inspect front drain hoses to ensure proper routing. without pinching or kinking.

-

Ensure that drain tube check valves are free of wax and/or debris.

Note:

Never trim, modify or remove drain hose check valves, as this will prevent water from draining properly.

-

Check all anchor points to ensure that hose is not partially disconnected.

-

Verify that rear drain hose routing (arrows indicate incorrect routing) maintains a level or downward track.

Note:

If the drain tube is positioned higher than the frame, water will back up in catch tray, causing a leak.

-

Check condition of drain tubes, and replace with Part No. 4A9 877 233 (front or rear) if any deformation is found.

CAUTION!

Part numbers are far reference only. Always check with your Parts Dept. for the latest parts information.

-

Repeat water test before re-installing interior trim.

Note:

It is normal for same water to leak around sunroof seal during water test.

-

Clean interior trim. See Technical Bulletin Group 70. Number 00-01 dated Aug. 23, 2000 for detailed cleaning instructions

-

If interior trim cannot be cleaned, replace as necessary.

-

Re-install headliner in reverse order of removal. See Repair Manual, Repair Group 70, Interior Trim.

All Other Service Bulletins for Wheel Speed Sensor:|600101|Page 3810 > < All Other Service Bulletins for Wheel Speed Sensor:|600101