A8 Quattro Sedan V8-4.2L (AUX) (2001)
-
Connect VAG1527B diode test lamp with test leads from VAG1594 connector test kit on socket 1 of connector (B+) and engine Ground (GND).
-
Activate starter for a few seconds. Engine can also start.
The diode test lamp must light up.
If the diode test lamp does not light up, carry out the following checks.
-
Check fuse for engine mounts.
If the fuse is OK
-
Check wiring connection from socket 1 via fuse to fuel pump relay for continuity.
Checking activation for engine mounts
-
Disconnect harness connector of particular solenoid valve.
-
Connect VAG1527B diode test lamp with test leads from VAG1594 connector test kit on socket 1 of connector (B+) and engine Ground (GND).
-
Carry out output Diagnostic Test Mode (DTM) and activate particular engine mount. Refer to "Scan Tool Testing/Output Diagnostic Test Mode
(DTM) (Function 03)" under "Powertrain Management" See: Powertrain Management/Computers and Control Systems/Testing and Inspection
The diode test lamp must blink during activation of the engine mounts.
If the diode test lamp blinks continuously.