A8 Quattro Sedan V8-4.2L (AUX) (2001)
/Page-517002.png)
-
Remove remaining sealant from oil pan and engine block using electric drill and plastic brush attachment.
Note: Oil pan must be installed within 5 minutes of applying silicone sealer D 176 404 A2.
-
Cut off nozzle of tube at front marking (nozzle dia. approximately 3 mm or 5/16 inch).
-
Thickness of sealant bead: 2 to 3 mm (approximately 5/16 inch)
CAUTION! Part numbers are listed for reference only. Always check with your Parts department for the latest information
Note: The bead of sealant must not be thicker than 3 mm (approximately 5116 inch), as otherwise excess sealant will enter the oil pan and
obstruct the strainer in the oil intake pipe.
-
Install oil pan immediately and tighten all bolts initially to 5 Nm (44 inch lbs.).
-
Tighten bolts in crosswise sequence - final torque: 15 Nm (11 ft. lbs.).
-
Replace seal on oil drain plug and tighten to 30 Nm (22 ft. lbs.).
Note: After installing the oil pan, wait for about 30 minutes for the sealant to cure before filling with engine oil.
-
Fill with engine oil.
