A8 Quattro Sedan V8-4.2L (AUX) (2001)
Air Bag Control Module: Service and Repair
Airbag Control Module - J234 -, Removing And Installing
CAUTION: Note safety measures when working on airbag.
Removing
-
For vehicles with coded radio unit, radio/navigation system (RNS) note coding; ask if necessary.
-
Disconnect battery and remove negative pole.
-
Remove center console.
-
Disconnect left connector on control module - 1 -.
-
Remove 3 nuts.
-
Remove control module.
Installing
Installation is done in reverse sequence, noting the following:
-
Note spacer sleeves - 2 -.
-
Tighten nuts to 6 Nm (53 in.lb.).
-
Switch ignition on.
WARNING: When disconnecting the battery no person should be in the interior of the vehicle.
-
Connect battery
-
If the control module is replaced, it must be coded.