A8 Quattro Sedan V8-4.2L (AUX) (2001)
-
Install bolt - 2 - and tighten to 23 Nm (17 ft.lb.).
-
Install cover - 1 - over rear upper tether fixture.
NOTE: Cap - 12 - is only used to cover hole in rear filler panel trim when anchoring fixture is removed.
Rear Lower Anchors
NOTE:
-
Inside anchors are not recommended for attaching lower anchors of LATCH seat in the middle position. The three-point lap/shoulder belt should
be used.
-
Rear lower anchor attachments are not applicable to long wheel base (LWB) vehicles.
1
-
Rear lower anchor bracket
-
Remove rear seat.
-
Remove Bolts(4x)
2
-
Bolt-washer assembly (4x)
-
Tightening torque: 22 Nm
3
-
Socket head Torx bolts (4x)
-
Tightening torque: 30 Nm
NOTE:
-
Bolts - 2 - and - 3 - optionally installed, note varying tightening torques.
-
To install stationary rear backrest, push tabs behind lower anchor bracket.