A8 Quattro Sedan V8-4.2L (AUX) (2001)
/Page-251001.png)
Seat Occupant Sensor: Service and Repair
Occupied Seat Sensor For Rear Seat With Power Adjustable Individual Seats, Removing and
Installing
Occupied Seat Sensor For Rear Seat With Power Adjustable Individual Seats, Removing And Installing
Removing
CAUTION: Observe safety precautions when working on airbag.
-
For vehicles with coded radio unit, radio/navigation system (RNS) note coding; ask if necessary.
-
Disconnect battery ground strap/cable and cover negative pole.
-
Remove rear seat bench.
-
Remove cover for rear seat left and right.
-
Disconnect wire - 7 - with 2-pin connector - 6 - from wiring harness - 8 -.
-
Remove seat cushion with sensor mat and seat heater.
NOTE: Sensor mat for occupied seat sensor is available as replacement part only in connection with seat heater and seat cushion.
Installing
Installation is done in reverse sequence, noting the following:
CAUTION: Sensor mat must not be creased, otherwise mat will malfunction.
-
After installation, check function of sensor mat.
CAUTION: Observe installation instructions of the seats.
