A8 Quattro Sedan V8-4.2L (AUX) (2001)
/Page-990002.png)
-
Drive new sealing ring in to stop using pressure piece 3384.
-
Install impulse wheel for VSS -G22- (arrow) on drive flange and check installation position.
NOTE:
^
The driver on the impulse wheel must engage in the groove of the drive flange.
^
If necessary, apply Vaseline to the contact surface of the impulse wheel in order to keep it in proper position during installation.
-
Press bracket (together with ball bearing) onto left drive flange as follows:
Place drive flange on pressure plate VW 401.
Press bracket on using thrust disc VW 412, tube VW 415 A and driving sleeve 32-109.
CAUTION: The press tube 2040 shown in the illustration should not be used (it is too short). Use tube VIN 415 A instead
