A8 Quattro Sedan V8-4.2L (AUX) (2001)
Axle Shaft: Service and Repair
Overhaul
NOTE:
^
Constant velocity (CV) joints are packed with grease G-6, or equivalent.
^
When replacing the joint boot, grease joint again if necessary using the following table.
CV Joint Diameter:
Inner, 108 mm ( 4.25 inch)
Outer, 98 mm (3.86 inch)
Total amount of grease:
Inner, 120 g (4.2 oz)
Outer, 120 g (4.2 oz)
Grease in joint
Inner, 35 g (1.2 oz)
Outer, 80 g (2.8 oz)
Grease in boot:
Inner, 85 g (3.0 oz)
Outer, 40 g (1.4 oz)
Component Notes And Information
NOTE: During service procedures, refer to the component location illustration above and component notes below.
1
Circlip
-
Remove and install with standard commercial circlip pliers
2
Gasket
-
To install, remove protective film from adhesive backing and adhere to joint
3
Inner CV joint
-
Outer diameter 108 mm
-
Replace as complete part only
-
Pressing off, refer to Fig. 1, below.
-
Pressing on, refer to Fig. 2, below.
-
Greasing, see note above
4
Inner CV joint boot with cap
-
With vent hole