A8 Quattro Sedan V8-4.2L (AUX) (2001)
^
Install pinion without spacer sleeve.
^
Heat inner race for tapered roller bearing to 100°C (212°F) and install on pinion.
Notes:
^
Do not additionally treat new tapered roller bearings to measure turning torque. For this purpose, the bearings are already pre-treated with a
special oil.
^
Only install the spacer sleeve during subsequent turning torque adjustment (with shim "S3" already determined).
^
Install drive shaft flange and tighten pinion nut until correct turning torque is achieved.
Measuring turning torque