A8 Quattro Sedan V8-4.2L (BGK) (2006)
Installing
-
First install bracket.
-
Installation of the rear view camera system control module is the reverse of removal.
-
Perform calibration. Refer to => [ Rearview Camera System, Calibrating ] See: Testing and Inspection.
Rearview Camera
-
Switch off all electrical consumers.
-
Remove the key.
Removing
‹› The rear view camera (R189) is equipped with a trailing cable. The couplings to the vehicle wiring harness are located at the left below the vehicle
tool kit box.
-
Remove the rear lid trim panel.
-
Remove the screw - 1 - (4 Nm).
-
Remove retaining plate - 2 -.
The rear view camera - 3 - is secured to handle trim.
-
Remove rear view camera - 3 - with a suitable tool from the grip piece.