A8 Quattro Sedan V8-4.2L (BGK) (2006)
-
If a telephone is installed, say "telephone".
The speech dialog system switches to the telephone mode.
-
Press and hold the PPT button for approximately one second.
The speech dialog system responds with "Cancel" and is deactivated.
Speech Input Control Module, from 1 September 2008
‹› The voice control system is part of the information electronics control module 1 (J794) inside the glove compartment. It cannot be replaced alone.
‹› If it is faulty, then the information electronics control module 1 must be replaced.
-
Switch off all electrical consumers.
-
Remove the key.
‹› If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine. Use the Vehicle
Diagnosis, Testing and Information System (VAS 5051) to do so.
Removing
-
Remove the information electronics control module 1. Refer to => [ Information Electronics Control Module 1, from 1 September 2008 ] See:
Entertainment Systems/Service and Repair/Communication System.
Installing
-
Install the information electronics control module 1. Refer to => [ Information Electronics Control Module 1, from 1 September 2008 ] See:
Entertainment Systems/Service and Repair/Communication System.
Perform the following function test:
-
Switch on the radio (R).
-
Briefly depress PTT button on multi-function steering wheel.
A "Ping" tone sounds, the speech input system is active.
-
Say the command "Help"
Since the radio is active, the speech dialog system responds with "Commands for the radio are...".
Depending on the equipment, other functions can be selected:
-
If a telephone is installed, say "telephone".
The speech dialog system switches to the telephone mode.
-
Press and hold the PPT button for approximately one second.
The speech dialog system responds with "Cancel" and is deactivated.