A8 Quattro Sedan V8-4.2L (BGK) (2006)
-
Slide sun shade housing - 1 - on to door frame, when doing this the shafts in sun shade housing - 1 - must be guided in and shaft heads must be
visible.
‹› Sun shade must not pull itself into sun shade housing.
-
Tighten bolts - 2 - (Qty. 5) of sun shade housing. 3 Nm.
-
Connect harness connector - 4 - to sun shade control module.
-
Connect harness connector to window regulator motor.
-
A second technician is needed for the next two steps.
-
Open cover of sun shade housing again and pull out sun shade slightly.
-
Roll out shafts via the switch in roof module (approximately 150 mm).
-
Pull out sun shade far enough until it can be engaged on shafts.