A8 Quattro Sedan V8-4.2L (BGK) (2006)
‹› If the tab on the backside of the wiring harness breaks off, the wiring harness must be replaced => [ Wiring Harness in Transmission ] .
-
Insert wiring harness connector into transmission housing.
‹› Installation position: Flat part of rear collar faces downward; tabs on collar are horizontal.
-
Set mechatronics unit in place without using force, and at the same time insert stud of selector lever - arrow - into groove of selector slide - A -; if
necessary, move selector slide back or forth.
-
Tighten bolts - 1 - and - 2 - for mechatronics unit to 2 Nm.