A8 Quattro Sedan V8-4.2L (BGK) (2006)
-
Release fasteners - arrows - and lift off auxiliary relay carrier in electronics box.
-
Disengage the engine wiring harness on the E-box and free it up.
-
Remove and lift off electronics box.
-
Unclip plug-in sockets for multi-pin connectors.
Installing
Install in reverse order of removal, observing the following:
‹› Attach all cable ties at the same locations when installing.
-
Install glove compartment.
-
Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal
and tighten nut. ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
-
Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] See: Wiper and Washer Systems/Wiper Arm/Adjustments.
Tightening Specifications