A8 Quattro Sedan V8-4.2L (BGK) (2006)
-
Connect test box (VAG1598/31) at wiring harness to Engine Control Module (ECM), do not connect ECM.
-
Check wire connection from respective sensor coupling...
-
... to Engine Control Module (ECM) for wiring open circuit as well as short circuit to B+ and to Ground (GND).
Knock Sensors 1 G61, Bank 1
Knock Sensors 2G66, Bank 2
Wire resistance: max. 1.5 ohms
-
Repair open circuit in wiring or short circuit if necessary.
If there is neither an open circuit in wiring nor a short circuit, replace Engine Control Module (ECM).
-
Read readiness code => [ Readiness Code, Reading ] See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes. If DTC memory was erased, readiness code must be generated again => [ Readiness Code, Generating ] See: Computers and
Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.