A8 Quattro Sedan V8-4.2L (BGK) (2006)
/Page-4359005.png)
-
Insert wire end from front up to stop into jaws of pliers and squeeze the pliers completely.
-
Open pliers again and remove the stripped wire end.
-
Twist bare strands one-half turn.
-
For the repair of a 0.25 mm 2 wire, use a small yellow crimp connector from the Wiring Harness Repair Set (VAS 1978A).
-
To press the crimp connector, use the Crimping Pliers (Base Tool) (VAS 1978/1-2) with Exchangeable Head, 0.35-2.5mm² (VAS
1978/1-1).
-
Slide the small yellow crimp connector onto both stripped, uninsulated wire ends on the vehicle-specific single wire and crimp them using crimp
pliers.
