A8 Quattro Sedan V8-4.2L (BGK) (2006)
/Page-3484003.png)
-
Remove four securing bolts (arrows -A- and -B-) from support bracket.
-
Push rear final drive as far as possible to right.
-
Lift left side of rear final drive (arrow -A-).
-
Push inner CV joint outward (arrow -B-) and pivot axle shaft out from below.
-
Place drip tray underneath.
-
Remove flange shaft securing bolt by threading two bolts into flange and counterholding flange shaft using a lever.
-
Pull out flange shaft.
-
Pry out dust ring using a screwdriver.
Note:
The dust ring will be damaged on removal and must be replaced.
