A8 Quattro Sedan V8-4.2L (BVJ) (2008)
3 - Metal Screw
‹› 1.5 Nm
4 - Bolt
‹› 1.5 Nm
5 - Expanding Clips
‹› Press in clamping pins only approximately 5 mm and pull out expanding clip released by doing this.
‹› Before installing, slide back clamping pin.
‹› After installing, press in clamping pin flush.
6 - Quick-Release Screw
Front Wheel Housing Liner Rear Section
Mounting Points
1 - Rear Section of Front Wheel Housing Liner
‹› Front wheel removed
2 - Metal Screw
‹› 1.5 Nm