A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-972003.png)
-
Disconnect electrical connectors - 1, 3, 4, 6, 8 - and free up wiring harness.
-
Remove Hall sensor - 9 -.
-
Remove crankcase ventilation hose - 7 - by pressing release buttons.
-
Place wiring harness on engine.
-
Remove front coolant hose - 2 - from left lower coolant line.
‹› Ignore - 1 -.
-
Remove nuts - 2 through 4 - accessible from above.
-
Remove heat shield - A - from threaded pins.
-
Remove heat shield - B - upward.
-
Disconnect electrical connector on ABS control module - arrow -.
