A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-630006.png)
‹› The tabs on the rear side of the bearing race must engage in the corresponding cut-outs on the front final drive intermediate flange.
-
Check whether shim - 1 - is still inserted.
-
Replace the rear flange shaft seal. Refer to => [ Rear Flange Shaft Seal ] .
-
Install the self-locking center differential - arrow - on input shaft splines, rotate slightly.
-
Make sure the installed self-locking center differential can be turned by hand.
-
Replace the O-ring in self-locking center differential cover.
