A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2202007.png)
-
Cut corrugated tube to appropriate length.
‹› Use air hose pliers (VAS 6228) or a sharp knife for cutting.
‹› The corrugated tube must not be cut through using a side cutter under any circumstances
‹› The corrugated tube must be cut on the wave peak - arrow -, not in the wave trough.
-
Guide fiber-optic cable into Crimping Pliers For Fiber-optic Cable (VAS 6223/10) as shown in illustration.
-
Position Crimping Pliers For Fiber-optic Cable at slot of corrugated tube.
-
Position Crimping Pliers For Fiber-optic Cable at slot of corrugated tube. By doing this, fiber-optic cable is fed in corrugated tube.
Fiber Optic Cable, Separating from Wiring Harness Connector
Removing
