A8 Quattro Sedan V8-4.2L (BVJ) (2008)
Catalytic Converter: Service and Repair
Right Exhaust Manifold With Catalytic Converter
Right Exhaust Manifold with Catalytic Converter
Special tools, testers and auxiliary items required
‹› Engine Support Bridge (10 - 222 A)
‹› Adapter (10 - 222 A /21)
‹› Drip Tray for Workshop Crane (VAS 6208)
‹› Engine Support Supplement Set (T40093)
Removing
‹› During installation, all cable ties must be re-installed at the same location.
CAUTION!
Risk of destroying electrical components when battery is disconnected.
‹› Observe measures when disconnecting battery.
-
With ignition switched off, disconnect Battery Ground (GND) cable.
-
Remove rear engine cover - arrows -.
-
Drain coolant. Refer to => [ Cooling System, Draining and Filling ] See: Engine, Cooling and Exhaust/Cooling System/Service and
Repair/Procedures.
-
Remove right coolant pipe. Refer to => [ Right Coolant Pipe ] See: Engine, Cooling and Exhaust/Cooling System/Coolant Line/Hose/Service and
Repair/Right Coolant Pipe.
-
Remove ribbed belt. Refer to => [ Ribbed Belt ] See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive
Belt/Service and Repair/Ribbed Belt
-
Remove generator.
-
Remove right front muffler. Refer to => [ Right Front Muffler ] See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and
Repair/Right Front Muffler.
-
Remove electrical harness connectors from bracket and disconnect it: