A8 Quattro Sedan V8-4.2L (BVJ) (2008)
-
Pry out lower clamping strip - 9 - using a screwdriver.
-
Pull the cover - 8 - down over the bracket - 7 -.
-
Turn back cover in area of side airbag - 2 -.
-
Unzip - 1 - protective cover of side airbag - 4 -.
-
Open securing clip at side airbag connector - 5 - and disconnect connector.
-
Turn back cover and upholstery in area of side airbag - 2 - far enough so the back side of the side airbag is accessible.
-
Remove nuts - 6 - (Qty. 2).
-
Remove side airbag - 2 -.
‹› Installing
-
Install side airbag - 2 - in reverse order of removal.
-
Close zip fastener - 1 - on protective cover for side airbag - 4 - using Closing Pliers (VAS 6138) or Pliers For Rear Side Airbag, Audi (VAS
6273), different zip fasteners have been installed.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect battery ground strap.
3 - Side retaining strips
4 - Protective cover for side airbag
5 - Connector for side airbag
6 - Nuts (Qty. 2)
7 - Retainer
8 - Cover
9 - Lower retaining strip
‹› Follow the safety precautions after connecting the battery.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) signals a malfunction after installation, DTC memory must be checked, erased and once again
checked using Vehicle Diagnosis, Testing and Information System (VAS 5051 A).