A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2673002.png)
‹› Trim on A-pillar, B-pillar, C-pillar, D-pillar
‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region
In addition:
‹› all seat belts with triggered belt tensioners
A - with deployed airbag control module
-
Connect a suitable vehicle diagnostic tool, e.g. Vehicle Diagnosis, Testing and Information System (VAS 5051 A) and tap "15 - airbag" in vehicle
system selection. Ignition must be switched on.
Front belt tensioner:
-
Read measuring value block display group 001:
You can recognize deployed belt tensioners by display "too great".
Rear belt tensioner (optional equipment/for specific countries):
-
Read measuring value block display group 002:
You can recognize deployed belt tensioners by display "too great".
B - with replaced airbag control module:
-
Connect a suitable vehicle diagnostic tool, e.g. Vehicle Diagnosis, Testing and Information System (VAS 5051 A) and tap "15 - airbag" in vehicle
system selection. Ignition must be switched on.
-
Retrieve DTC memory:
You can recognized deployed belt tensioners by malfunction message "Belt tensioner - resistance value too great".
