A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2027013.png)
-
Slide the small yellow crimp connector onto the vehicle-specific single wire at one side and onto the repair wire at the other side.
-
Crimp the crimp connection at both wire ends using crimp pliers.
-
Repeat this procedure at the other repair wire end.
‹› Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.
-
Put Shrink Tip For Hot Air Gun (VAS 1978/15) on to Hot Air Gun, 220 V/ 50 Hz (VAS 1978/14).
