A8 Quattro Sedan V8-4.2L (BVJ) (2008)
/Page-2362003.png)
2.
Once the links are removed from the vehicle, hold the link in a vice with protective jaw covers. Assemble the 3348 and 3301 tools as shown in
Figure 6.
Tighten the nut until the bushing is pressed out.
3.
Place and align the new bushing in the link as shown in Figure 7 with the cutouts (see arrows) placed and aligned in the link according to Angle A.
This angle must be 90° +/- 1°.
Note:
Improper alignment of the bushing may cause premature wear and failure of this bushing.
4.
Press the bushing into place. Assemble the 3348 and 3301 tools as shown in Figure 8.
Tighten the nut until the bushing is pressed into place.
5.
Reinstall the front and rear links on both sides from the vehicle as described in the ElsaWeb Repair Manual.
Warranty
When procedure applies to vehicles under warranty, use the following:
